The FIBERLIGN dielectric support (FDS) system is designed to gently, but firmly, support all dielectric Self-Supporting (ADSS) cable
It is intended for tangent support installations (see "LINE ANGLES") on lines that feature relatively low voltages, short spans and modest mechanical loads
For Higher voltages (where "track resistant ADSS cables are required)
Longer spans and/or Higher loads, use either the FIBERLIGN aluminum suspension with rods or the FIBERLIGN dielectric suspension both products appear later in this section
The maximum recommended span length for the FDS is dependent upon the specific cable OD initial cable tension, ice and wind loading district (NESC), and other factors
It is intended for application on relatively short spans where vertical cable loading does not exceed approximately 1000
In general, the approximate recommended maximum span lengths for the FDS are 600 ft for
The body and top are made from a high strength, engineered dielectric material
The cushioned inserts are made from a soft, pliable dielectric material that gently grips the ADSS cable
Two captured zinc plated bolts with washers secure the top to the body
The body threads onto standard 5/8 in 11 UNC hot dipped galvanized thru-bolt and may be mounted either horizontally or vertically
For horizontal mounting to a wood pole (or other structures with through hole) a double arming bolt (completely threaded-no head) is suggested instead of a fixed length machine bolt
This allows approximately 1-5/8 in of bolt length to thread into the body regardless of pole diameter
For mounting to concrete or steel structures without thru holes, use a 5/8 in threaded stud of appropriate length or banding system with a mounting bracket
For most applications, the maximum line angle recommended is 20 deg, consult PLP® for exceptions that allow 30 deg angles
When angles exceed 20 deg (or 30 deg ) a double dead end arrangement is usually preferred
A special double FDS unit can be designed for certain applications
The cushioned inserts are designed to gently grip the cable while providing significant slip strength without causing cable jacket damage
Specific performance will depend upon the specific cable O.D. and design

PLP44009878电源支持使用:ADSS电缆规格:Dia0.751对0.825

PLP44009878电源支持使用:ADSS电缆规格:Dia0.751对0.825

盘点

产品简介

产品规范

文件编译